Hi Tom, no, in my case... in QA Complete, when I click on a test result for one of the tests that show as it ran over two hours... it simply states. Failed and no records found.
Really weird.
Hi azwip,
our problem startet right after a windows 10 update on our test clients.
Hmmm, I'll have to check into that.... its just really strange... like last nights run, again, a random test... shows it "ran" for almost" 3 hours.... but, in QAComplete, no results... so I can't see what may have happened.... and in TestComplete... under results, that test is not even listed???
But, next run, changing nothing... runs fine and dandy.
So, still not sure what is happening.
Anyone else seeing this?
Every night now... random tests... out of 50, at 3 or 4, show in QAComplete as taking well over 2-3 hours....
but, no info in the log, I have no way to see what is happening. The test before and the one after, all show fine.
Then, in TestComplete itself, the logs.... do NOT even show those Long running tests (thave have no log at all in QAComplete).
For example, If I have:
Test1
Test2
Test3
thru
Test 50
Each test normally runs for 10 mins... and their log (pass or fail) can be seen in QAComplete run history and of course in TestComplete
At random, I may see (In QAComplete) as an example:
Test1 - Started and completed (09:00/09:10)
Test2 - Started and Completed (09:10 / 09:21)
THEN:
Test3 - Started and Completed (09:22 / 13:01) - Over 3hours!!!!
Test4 - Started and Completed (13:02 / 13:11)
etc etc...
QAComplete displays result for all the above... but says no records for that 3+ hour run!
TestComplete does not show a log at all for Test3 (the 3+ hour run)
In TestComplete I hav logs for all tests, except the ones that run for a ridiculous length of time.... its like they didnt even exist.
Next time i run, those tests (e.g. Test3) will run flawless and the same problem will occur with a different test(s)
I can't even see a log to see what the heck is happening... Lol
Any ideas?
Thanks again!
Hi,
yesterday me and a coworker where able to see this in Testcomplete:
We have an Onstop Event which is just the logoff from our application. The Test ran and we could see the click on the logoff button. Our application went into “no response”. This is where the test are for. Our DEV people are searching for an error in our application. Anyway after several minutes our application window disappears but we could still see the Testexecute widget for about 5 minutes. When the Testexecute widget disappears too as well as Testcomplete. We restarted Testcomplete and where was no log of the Test. Where even were no Windows logs of the crash of our application or Testcomplete/Testexecute. So Testcomplete/Testexecute could as well have crashed first and took our application with it.
Additionally I’ve found false positive tests in QAComplete. The result is shown as passed but if we look into the results, the log stops in the middle of the test and the other test steps are just missing without any error.
So I think Testexecute crashes and QAC don’t get it.
Did you open a support Ticket? It might help Smartbear.
Regards
Tom
