Forum Discussion

azwip's avatar
azwip
Occasional Contributor
6 years ago

QAComplete and test run. Gap in test execution

Howdy folks... ok, have a suite of about 60 tests.... have them scheduled... and executed on remote system....   In the past few weeks... I have noticed an extra long test execution timen for the...
Tom_Test's avatar
Tom_Test
Contributor
6 years ago

Hi azwip,

 

I have a support ticket for something similar.

 

When you click in QAComplete on the test without a log, is the actual result: "TestComplete (TestExecute) was terminated for an unknown reason."?

 

I could find the logs on my test client, QAC just didn't get them from there. Same at yours?

 

Regards,

Tom

  • azwip's avatar
    azwip
    Occasional Contributor
    6 years ago

    Hi Tom, no, in my case... in QA Complete, when I click on a test result for one of the tests that show as it ran over two hours... it simply states. Failed and no records found.

     

    Really weird.

    • Tom_Test's avatar
      Tom_Test
      Contributor
      6 years ago

      Hi azwip,

       

      our problem startet right after a windows 10 update on our test clients.

      • azwip's avatar
        azwip
        Occasional Contributor
        6 years ago

        Hmmm, I'll have to check into that.... its just really strange... like last nights run, again, a random test... shows it "ran" for almost" 3 hours.... but, in QAComplete, no results... so I can't see what may have happened.... and in TestComplete... under results, that test is not even listed???

         

        But, next run, changing nothing... runs fine and dandy.