| I turned off the auto-create defect function while teaching myself QA Complete. Despite hours of searching this site and the internet in general, I have been unable to figure out how to turn it back on. Can anyone help me? Thanks! |
Hello Linda,
You can turn on the option for "Automatically create a defect when a test fails." by doing the following.
Navigate to the Setup Tab > The System Configuration Folder on the left folder navigation screen.
Select "System Options" > Navigate to the "Confirmations:" section.
Make sure "Automatically create a defect when a test fails." is selected, if not, click the box and then click submit at the bottom of the page.
Here is a quick video walk-through of the above steps:
http://screencast.com/t/2w0aYPbLThanks!
Will
