Passing a previously failed test case
Hi, The defects we raised against failed test cases are fixed pretty quickly. So we retest the defects while at the same time running tests within the same Test Sets. We don't see however any w...
Forum Discussion
Hi Edna,
You cannot go back into the run and change the status of a test that was already run - that would change the history for that test, and you need to see that it was run on that date, in that test set. When a test is Paused, you can only continue running the tests in the set that were not run. The tester needs to finish the run - or end it as incomplete, which closes off the run - then start the test set again.
If the tester only needs to re-run a few of the test in the original run, they need to set up a smaller test set with only those tests.
Hope this helps!
You cannot go back into the run and change the status of a test that was already run - that would change the history for that test, and you need to see that it was run on that date, in that test set. When a test is Paused, you can only continue running the tests in the set that were not run. The tester needs to finish the run - or end it as incomplete, which closes off the run - then start the test set again.
If the tester only needs to re-run a few of the test in the original run, they need to set up a smaller test set with only those tests.
Hope this helps!
