Forum Discussion
stevenerat
13 years agoOccasional Contributor
I installed LC 2.5 Beta 2 on another client machine. There, I reproduced the issue where after creating a simple test and saving it, the green Run button on the top menu bar was not enabled and appeared gray. This was a simple recording with about 20 requests (after I cleaned up all the images and other static files). There was no parameterization done yet. At the same time, if I right click on a test name then the fly out menu did have a green Run button and I was able to use that.
So the workaround is to use the flyout Run button off the test instead of the top menu bar. If I close and reopen the project in LC, the top menu bar continues to show the Run button as disabled/gray. I'm attaching a screenshot.
---
Edited to read the top menu bar button was gray (not green).
Also I am now uninstalling LC2.5 Beta 2 completely and will install 2.5 Final that I just downloaded.
So the workaround is to use the flyout Run button off the test instead of the top menu bar. If I close and reopen the project in LC, the top menu bar continues to show the Run button as disabled/gray. I'm attaching a screenshot.
---
Edited to read the top menu bar button was gray (not green).
Also I am now uninstalling LC2.5 Beta 2 completely and will install 2.5 Final that I just downloaded.
Related Content
- 8 years ago
- 8 years ago
- 7 years ago
- 8 years ago
Recent Discussions
- 9 months ago
- 2 years ago
- 3 years ago
- 3 years ago