Forum Discussion

Janett's avatar
Janett
Occasional Contributor
10 years ago

Why Bi-modal graph is generating when simulating simultaneous requests in LoadComplete?

I am new to LoadComplete. I have gone through the required guidelines to test a scenario. The problem I encountered is,   I simulated total of 20 virtual users to monitor the performance of a websi...
AlexKaras's avatar
AlexKaras
Community Hero
10 years ago

Hi,

 

Thank you a lot for the update on the problem.

May I ask you for the screenshot of the problematic scenario to get a better understanding on what setup causes the mentioned problem?

Janett's avatar
Janett
Occasional Contributor
10 years ago

Hi AlexKaras,

 

I have already attached the screen shots of the problem to Mr. Ryan's comments. Anyway I'll attach it again....

  • AlexKaras's avatar
    AlexKaras
    Community Hero
    10 years ago

    Hi,

     

    No, I was talking not about results screenshots, but about screenshot of the scenario that produced these results. (The one been executed by LoadComplete.)

    Did it contained two tests? Or, maybe, it were two scenarios one of which was executed on the local machine while another one was executed on remote machine? Or, maybe, some other setup?

    • Janett's avatar
      Janett
      Occasional Contributor
      10 years ago

      Hi,

       

      I have attached the screenshot.

      It contains only one test and scenario.

       

      Regards

       

       

      • AlexKaras's avatar
        AlexKaras
        Community Hero
        10 years ago

        Hi,

         

        > I have attached the screenshot.

        Oh-h, my bad - I am always mixing up 'scenario' and 'test' terms in LoadComplete and while I was talking about scenario I actually meant the test and its screenshot. :( Sorry for this.

        So I will appreciate if you can provide screenshot for the test3 setup, but even if not I hope that Ryan will share his findings here.