Forum Discussion

brian_daniel's avatar
brian_daniel
Occasional Contributor
11 years ago

End Run Pop-up Rendering Issue

Has anyone seen the issue in the attached image before and know what is causing it?

Procedure to recreate:
1. Run a test.
2. Click end run without completing the whole test.
3. Pop-up displays as shown in the attached image.

System is running Windows 7 with IE11 (also tried in compatibility mode and still had same issue)
  • WWoodford's avatar
    WWoodford
    11 years ago
    Has anyone seen the issue in the attached image before and know what is causing it? Procedure to recreate: 1. Run a test. 2. Click end run without completing the whole test. 3. Pop-up displays as shown in the attached image. System is running Windows 7 with IE11 (also tried in compatibility mode and still had same issue)




    Hi Brian,



    This is likely caused by the use of IE 11 or IE 10, as they are not currently supported browsers. I personally use either Firefox or IE 9, and have no rendering issues. If you could please try again using Firefox or if possible IE 9 and let me know if the rendering issue goes away.



    Thanks!
  • WWoodford's avatar
    WWoodford
    Staff
    11 years ago
    Has anyone seen the issue in the attached image before and know what is causing it? Procedure to recreate: 1. Run a test. 2. Click end run without completing the whole test. 3. Pop-up displays as shown in the attached image. System is running Windows 7 with IE11 (also tried in compatibility mode and still had same issue)




    Hi Brian,



    This is likely caused by the use of IE 11 or IE 10, as they are not currently supported browsers. I personally use either Firefox or IE 9, and have no rendering issues. If you could please try again using Firefox or if possible IE 9 and let me know if the rendering issue goes away.



    Thanks!
  • brian_daniel's avatar
    brian_daniel
    Occasional Contributor
    11 years ago
    That was the issue. It works fine in IE8 and Firefox. IE11 does not display correctly. It also doesn't seem to let me set compatibility mode. Thanks for the reply.