Contributions
- 3.1KViews0likes0Comments
Re: Threads not starting with DataSource Loop
I have 1000 rows on the file so the first scenario doesn’t apply. However I have set the test to 1 run. I thought it meant that the test should run only one time – this is, a full cycle over the text file input data – and that the run would be shared by N threads. I’ll try setting the number of runs equal the number of threads. However I cannot have more than 1 request using the same data. I wish to have exactly 1000 unique requests shared by N threads. Unfortunately I’m away today and I cannot test it until Monday. I cannot wait to do it… Thanks for the quick reply.3.1KViews0likes0CommentsThreads not starting with DataSource Loop
Hi, I was testing a Web service with SoapUI and it seemed not to scale at all. I was getting very worried (still am). Then I introduced a delay step with a few seconds and watched what happened: It doesn’t matter how many threads I specify on LoadTest, soapUI is only sending a new request after the delay specified! What am I doing wrong? I’m using the following test steps: - DataSource (to a file, shared and preload flags specified) (*) - Property Transfer - Delay (2500ms) - The Request to my web service - DataSourceLoop to “Property Transfer” If I run the test for about 5 seconds with 10 threads (Stretegy: Simple, Test Delay: 0) I was expecting a total count of 10*(5/2.5)=20 requests but instead I have only 2! What is happening? Thank you. (*) Even with "shared: off" the threads don't start as expected.8.7KViews0likes4Comments