Ask a Question

Groovy log UI updates stop after some time, don't resume until after a restart

M_McDonald
Super Contributor

Groovy log UI updates stop after some time, don't resume until after a restart

When I am running a test case in the UI, the display of Groovy logging stops after a few hundred lines (not a consistent number), and will not begin again until I close and reopen soapUI.

Output of test cases run from TestRunner shows all Groovy logging.

I am using build daily-2009-05-08-[1].
"Ignorance more frequently begets confidence than does knowledge"
10 REPLIES 10

Re: Groovy log UI updates stop after some time, don't resume until after a restart

Hi!

thanks.. if you clear the groovy log via its right-click menu, does the logging pick up again in these situations?

regards,

/Ole
eviware.com


Did my reply answer your question? Give Kudos or Accept it as a Solution to help others. ⬇️⬇️⬇️
M_McDonald
Super Contributor

Re: Groovy log UI updates stop after some time, don't resume until after a restart

No, it just stays cleared, even if I run a different test case.
"Ignorance more frequently begets confidence than does knowledge"

Re: Groovy log UI updates stop after some time, don't resume until after a resta

Hi Mr. McDonald,


Could you run soapUI by executing the soapUI run script from the command line?

That way you should be able to see standard output where additional logging messages and then you would be able to provide us with extra information when Groovy logging stops. I suspect this could be a bug in log4j, the underlying logging library.

Thank you in advance!


Cheers!
/Nenad Nikolic a.k.a. Shonzilla


Did my reply answer your question? Give Kudos or Accept it as a Solution to help others. ⬇️⬇️⬇️
M_McDonald
Super Contributor

Re: Groovy log UI updates stop after some time, don't resume until after a restart

I ran a long test (the output was nearly 29000 lines) from the command line like this:

    testrunner.bat -sTestSuite -cTestCase -r -j -f C:\test\ -o -i project.xml

and redirected the output to a file. All Groovy log statements were in the output, so this only seems to happen in the UI.

On thing to note, some of the log output is extremely long, say 2500 chars with embedded CRs. Could that adversely affect on the UI behavior?

- Michael
"Ignorance more frequently begets confidence than does knowledge"
Mason
Frequent Contributor

Re: Groovy log UI updates stop after some time, don't resume until after a restart

I've seen the same issue.  The Groovy log stops working at some point.  Requires restart of SoapUI.

Re: Groovy log UI updates stop after some time, don't resume until after a restart

Hi,

the upcoming nightly build of the 3.0 beta should fix this (we've had a hard time reproducing..), please let us know if this is (or is not) the case..

regards!

/Ole
eviware.com


Did my reply answer your question? Give Kudos or Accept it as a Solution to help others. ⬇️⬇️⬇️
M_McDonald
Super Contributor

Re: Groovy log UI updates stop after some time, don't resume until after a restart

I now see all entries in the Groovy logs in the UI.

Thanks.
"Ignorance more frequently begets confidence than does knowledge"
Mason
Frequent Contributor

Re: Groovy log UI updates stop after some time, don't resume until after a restart

This issue still occurs for us.  After two or three runs of a suite, the Groovy Log stops updating.
alibaba82
Super Contributor

Re: Groovy log UI updates stop after some time, don't resume until after a resta

I have seen this too.
cancel
Showing results for 
Search instead for 
Did you mean: