No Log File - No Results????
Am running TC12 now, but even when running TC11... same issue. I have suite of tests that run well over 8 hours... So I kick 'em off... watch them running for a few hours... they are still runni...
Forum Discussion
If you are using the /silentmode switch in command line (I'm assuming you're running via command line), then there is a "silent log". Check <System_Drive>:\Users\<UserName>\AppData\Roaming\SmartBear\TestComplete\12 to see what shows up.
Also, do you have your testcomplete/testexecute configuration set up to auto-save logs? If not, I would do so. This could give you some back up of the test log so that, even if TestComplete crashes for some reason, you'll get a test log up to that point.
Hi Robert, thanks for the assist...
I'm not running in command line mode.... I am using the Green "Play" button to run my suite/project.
I do have Auto Save on, but nothing is being saved, from what I can tell.
Go check in the logs folder and see if there is anything showing up out there. While the project might not display it, the log file MIGHT be present. If TestComplete is crashing at some point, it might not be updating the tcLogs file which is the link between the MDS and the individual log files.
