Focus on TestExecute to display manual checkpoint prompts.
I am using TestExecute to run tests I created in TestComplete. I have manual checkpoints as well as messages generated using BuiltIn.ShowMessage("This is my message"). When my test runs, it simply pauses where it was when getting to either the message or manual checkpoint rather than displaying either the message or manual checkpoint prompt. It doesn't display either one unless I click the testexecute bullseye in the upper right hand corner. Below is a screenshot of where a message is supposed to appear. Instead, execution just pauses and the message isn't visible unless the message in the upper right hand corner is clicked. I would like it to just show up to make it easier for my testers.