setting up parameters in Load Test in SOAP UI
Hi,
I am doing load test at different layers of SOA architecture. I am testing failover for DSP layer.
I have the 4 different kinds of Load Strategy. When both nodes of DSP are up and sned the request it is getting balanced among the 2 nodes. when I bring down one of the nodes , then I see failure in the Load Test Log.
May I know what could be the reason for these errors. Also I would like to know if any parameters have to be setup at any level in options of the tool.
Your help at point in time is highly helpful.
Usha
I am doing load test at different layers of SOA architecture. I am testing failover for DSP layer.
I have the 4 different kinds of Load Strategy. When both nodes of DSP are up and sned the request it is getting balanced among the 2 nodes. when I bring down one of the nodes , then I see failure in the Load Test Log.
May I know what could be the reason for these errors. Also I would like to know if any parameters have to be setup at any level in options of the tool.
Your help at point in time is highly helpful.
Usha
