Forum Discussion

Apoorva6's avatar
Apoorva6
Frequent Contributor
9 years ago

Need help in acheiving dynamic data load and filter back response from file

I have 2 test steps. (note that inbetween these two, there are many transactions triggered) . The attachment has detailed steps. It has STEP1 and STEP2.   STEP1: Request1 when triggered must write ...
nmrao's avatar
nmrao
Champion Level 3
9 years ago
Is it just fixed response for fixed request? Any conditions?
  • Apoorva6's avatar
    Apoorva6
    Frequent Contributor
    9 years ago

    Hi Rao,

     

    Initial file will be fixed. In STEP1 account numbers to be written to that file will be dynamic which is BillingAccountNumber. Later in STEP2, same Request to get filtered Response back with the account numbers.

    • nmrao's avatar
      nmrao
      Champion Level 3
      9 years ago

      The accurate information in the question will have better results.
      Just one thing it is noticed that both requests are different, i.e., represent different operations.
      It would be better if you can show mapping between each request and respone i.e., which value of the request (put place holder) goes to which value of the response (put place holder). Do the same for both requests and responses.

    • nmrao's avatar
      nmrao
      Champion Level 3
      9 years ago
      Also note that, here you must be implementing two mock operations -

      1. BillAccountPackageReadResponse
      2. BillAccountWriteResponse
      • Apoorva6's avatar
        Apoorva6
        Frequent Contributor
        9 years ago

        Hi Rao, Yes, I have updated modified file with my comments. I have named STEP1.REQUEST, STEP1.RESPONSE, STEP2.REQUEST and STEP2.RESPONSE  for simplification in file. I have mentioned which values I need / will be set from STEP1.REQUEST to STEP2.RESPONSE. Just to ensure that the account numbers (dynamic values) must be written to file so that we have other transactions which can use them.