Forum Discussion

scelik's avatar
scelik
New Contributor
8 years ago

Session is closed while sending messages to Tibco EMS queue

Hi,   When I send multiple textmessages to a Tibco EMS queue within a loop, I get sometimes the following exception for some messages:   Thu May 12 13:32:13 CEST 2016:WARN:Error Response javax....
nmrao's avatar
nmrao
Champion Level 3
8 years ago
What are the test steps in your test case?
Are you closing connection after each call?
  • scelik's avatar
    scelik
    New Contributor
    8 years ago

    Hi Rao,

     

    My testcase is:

    - Datasource 1 to read messages from an excel file

    - JDBC call to count the records in a table in the database

    - JMS request to send a message

    - JDBC call to count again and one assertion (result should be +1 relative to the first JDBC call to check the message is processed)

    - Datasource loop (back to "JMS request to send a message"

    - Datasource 2 to read messages from another excel file

    - JMS request with a message from datasource 2

    - JDBC call to make sure some fields are changed

    - Datasource loop (back to  "JMS request with a message from datasource 2")

     

    In the first datasource I send 20 messages and in the second 10 messages. I do not close the connection. I get the exception in both of these JMS request steps. 

    When I change the configuration of my application and SoapUI project to use the EMS server on my local machine (laptop), this exception never occurs.

     

    Regards, 

    Sinan

    • nmrao's avatar
      nmrao
      Champion Level 3
      8 years ago
      May be you can try again after setting the below change:
      Go to File -> Preferences ->HttpSettings -> Close connection after each call-> check it and save the preferences.
      And retry your case to see if that is reproducible.
      • scelik's avatar
        scelik
        New Contributor
        8 years ago

        Hi Rao,

         

        Thanks for your suggestion. "Close connection after each call" was disabled. Turning it on didn't help :(

        I also tried by setting the "reconnects" property in Hermes Configuration to "0", "1" and "2".

         

        Regards,

         

        Sinan