Contributions
Re: Aqtime is not generating results when the host application ends
Hi, I contacted support by raising a customer care ticket and got a solution which worked for me to get the results automatically when the profiled application closed. This is why results weren't generating in the first place: AQtime doesn't generate profiling results if your application crashes or terminates with a non-zero exit code. In this case, the application is not finalized correctly, so AQtime cannot collect profiling results properly. However, AQtime has a mechanism to overcome the situation. And below is the solution suggested: Complete the following two steps: 1) Download and install the latest version of the tool. You can download AQtime 8.60 from AQtime's product page after you log in to the website using your registration information: https://my.smartbear.com/ 2)Enable the Get results at early finalization phase option in the General Preferences dialog (Options | Options... | General | General Preferences) of AQtime. I have AQtime 8.40 installed and I did the 2nd option. By doing thisresults were generated automatically. Thank you for the support. Regards, Abe8 years agoPlace AQtime QuestionsAQtime Questions4.9KViews2likes1CommentAqtime is not generating results when the host application ends
Hi, I am using AQ Time to generate a light code coverage report for the modules I have added. I'm profiling dlls and I have added the host application to load these dlls. WhenI start my aqt project, it starts the application and profiling happens.But when theprofiling ends or when the application is closed, results are not getting generated. If I manually click the "Get Results" button then the results are populated in the report panel. My understanding is when profiling,results are generated when the host application exits. I have gone through the AQtime Troubleshooter but with no results. Please help. Thanks in advance!!! Regards, Abe8 years agoPlace AQtime QuestionsAQtime Questions5KViews0likes3CommentsRe: Application runs, but AQTime doesn't show results
Hi, I am using AQ Time to generate a light code coverage report for the modules I have added. I'm profiling dlls and I have added the host application to load these dlls. WhenI start my aqt project, it starts the application nd profiling happens.But when theprofiling ends or when the application is closed, results are not getting generated. If I manually click the "Get Results" button then the results are populated in the report panel. But my understanding is when profiling,results are generated when the host application exits. Please help. Thanks in advance!!!8 years agoPlace AQtime QuestionsAQtime Questions4.3KViews0likes1Comment